














LD16/LD32 Laser Level Gauge
The LD16 and LD32 are laser level meters for continuous non-contact measurement of bulk solids. A narrow laser beam is fired at the surface of the product and the time of flight gives the distance, so the instrument never touches the material and is not affected by its density, colour or temperature. The LD16 measures 0.5 to 16 m and the LD32 up to 32 m, both with a 650 nm visible aiming spot plus a second reference wavelength, which makes the beam easy to aim during installation and keeps the reading stable on a dusty surface. A full metal housing and a modular optical block give the units resistance to vibration and to high ambient temperature, and the update rate is adjustable from one to ten measurements per second so the reading can follow a fast-changing bin or be averaged for a calm display. Both models are sealed to IP65 and run from 24 V DC, and a switching output can be added for a high-level alarm.
· Non-contact laser time-of-flight measurement: nothing enters the product, so abrasive, hot and sticky materials cause no wear.
· LD16 covers 0.5 to 16 m and LD32 covers 0.5 to 32 m, both with a 650 nm visible aiming spot for easy alignment.
· A second reference wavelength keeps the reading stable on a dusty surface where a single-colour sensor would drift.
· Measurement rate adjustable from one to ten times per second, so the same unit serves a fast bin and a calm display.
· Full metal housing and modular optical block resist vibration and high ambient temperature in an industrial plant.
· 24 V DC supply, IP65 protection and an optional switching output for a high-level alarm or an interlock.
The LD16 and LD32 are used on silos, bins, stockpiles and hoppers holding ore, coal, clinker, sand, stone aggregate, grain and oilseeds, feed, wood chips, plastic pellets and other industrial bulk solids. They suit mining and metallurgy, cement, food and feed processing, pulp and paper, and the chemical and plastics industries, where a non-contact measurement is preferred because the product is abrasive, hot, or likely to coat a contacting probe.

Which model do I need, LD16 or LD32?
Measure the maximum distance from the mounting point to the lowest surface you have to read. If it is within 16 m, the LD16 is enough and gives ±0.1 m accuracy. Above 16 m, up to 32 m, use the LD32, which gives ±0.15 m. Both start at 0.5 m, so neither can read closer than half a metre.
How does dust on the lens affect the measurement?
The instrument uses a measuring wavelength plus a reference wavelength, and the reference compensates for the attenuation and scattering that dust causes. That is why the reading stays stable in a silo that is being filled, when a single-colour laser would drift or drop out.
What reflectivity does the product need?
The specified range applies to solid material with a reflectivity above 30 %, which covers most minerals, cement, coal, grain and pellets. Very dark or very absorbent products shorten the usable range, so tell us the material and we will confirm the model.
Can it be used outdoors?
Yes. The housing is metal and sealed to IP65, and the operating range is -10 to +50 °C with humidity up to 75 % RH without condensation. On an outdoor silo, fit a sun and rain hood and aim the instrument away from direct sunlight.
How is it aimed and commissioned?
The 650 nm beam is visible, so the spot can be placed on the product surface during installation. Set the empty distance and the span in the controller, choose the measurement rate that suits the process, and the 4-20 mA or switching output follows the level.
Solutions & Support
We go the extra mile to thoroughly analyze each project and deliver tailored business solutions that meet your specific requirements.
Copyright © 2026 singoo Technical supp
Contact US
×




