






UNI800S Digital Weight Transmitter
The LONGTEC UNI800S is a compact panel-mount digital weight transmitter that turns a raw strain-gauge load cell signal into a stable, high-resolution weight value. It samples up to 200 times per second with an internal resolution of 1:16,000,000 and a non-linearity of 0.002% FS, so small changes inside a large hopper or tank stay visible instead of disappearing into the noise. Modbus TCP, EtherNet/IP and PROFINET connect it directly to a PLC, DCS or batching system, while an optional second RS-485 port drives a remote display. Digital or physical calibration, sensor fault diagnostics and replacement without re-weighing keep commissioning and maintenance short. The all-metal housing and 73 x 55 mm front suit dense control cabinets and existing 92 x 46.5 mm cut-outs.
· Internal resolution of 1:16,000,000 with 0.002% FS non-linearity resolves small weight changes inside large hoppers and storage tanks.
· Samples up to 200 times per second with dynamic digital filtering, so the reading stays steady while the vessel is stirred or filled.
· Modbus TCP, EtherNet/IP and PROFINET are available on the first port, with an optional RS-485 second port for a remote display.
· Digital or physical calibration plus sensor fault diagnostics allow a failed unit to be replaced without re-weighing the vessel.
· All-metal panel-mount housing, 73 x 55 mm front and only 45 mm deep, fits dense cabinets and existing 92 x 46.5 mm cut-outs.
· Wide DC18-36V input and isolated communication survive the noisy 24V supplies found on batching, filling and packaging machinery.
UNI800S transmitters are mounted in control cabinets and on machine frames wherever a weight signal has to reach an automation system: multi-ingredient batching machines, hopper and silo weighing, loss-in-weight feeders, bagging and filling lines, tank farms and platform scales. Typical industries are chemical and coating production, dry mortar and cement, plastics compounding, feed milling, food processing and metallurgy. The Ethernet fieldbus options make it a direct replacement for analogue 4-20 mA transmission where cable runs are long or several scales share one controller.


Which load cells can the UNI800S work with?
It accepts any resistance strain-gauge load cell, with DC5V excitation, a sensitivity range of 0.1 to 200 µV/d and an effective input range of ±30 mV. For tanks or hoppers with several cells, a summing junction box is used and the total signal goes into the one transmitter.
Can I connect it to my PLC without extra modules?
Yes. The first communication port carries Modbus TCP, EtherNet/IP or PROFINET, so the weight value goes straight onto the machine network. If you also need a local or remote display, order the second port as RS-485; the two ports work independently.
Do I have to recalibrate after replacing a unit?
No. The UNI800S supports replacement without recalibration: the calibration parameters can be carried over to the new unit, so the vessel or hopper does not need to be re-weighed with test weights.
What panel cut-out and depth does it need?
The cut-out is 92 x 46.5 mm and the front bezel measures 73 x 55 mm. Only 45 mm of depth sits behind the panel, which leaves room for wiring in shallow enclosures.
Will the reading stay stable on a vibrating hopper?
Yes. Dynamic digital filtering is applied to the 200 readings per second, which removes the effect of vessel shaking and agitator movement while still reacting quickly to real weight changes.
Solutions & Support
We go the extra mile to thoroughly analyze each project and deliver tailored business solutions that meet your specific requirements.
Copyright © 2026 singoo Technical supp
Contact US
×




