
















TR700-LF Loss-in-Weight Feeding Control Module
The LONGTEC TR700-LF is a dedicated loss-in-weight feeder control module in a DIN-rail enclosure. It reads the hopper weight through up to eight 350 ohm load cells, calculates the actual feed rate from the weight loss per unit time, and drives the feeder screw or belt with a second-level PID algorithm so the gravimetric flow stays on setpoint. An incremental control strategy keeps the output steady when the operator switches between manual and automatic, and a predictive model control law anticipates the effect of each control change, cutting overshoot on fast feeders.
· Gravimetric rate control calculates real kg/h from weight loss over time instead of running the screw open-loop.
· Second-level PID with a predictive model law anticipates each control change, giving fast response with small overshoot.
· Incremental control strategy keeps feeder output steady at the moment the operator switches between manual and automatic.
· Connects up to eight 350 ohm load cells at 10 V excitation over a 0.3 to 30 mV input with 16,000,000 internal resolution.
· Stand-alone operation or PWC network node, so feeders can be commissioned one by one and later linked into a batching system.
· Four isolated switch inputs and four relay outputs, plus 4-20 mA in/out, RS-485 Modbus, CANopen and Ethernet Modbus TCP.
TR700-LF modules control continuous gravimetric feeding of powders, pellets and granules: loss-in-weight feeders on extruders and compounders, continuous dosing into mixers, coal and mineral powder feeding, and any screw, vibratory or belt feeder that has to hold a constant kg/h rate. The module can run as a stand-alone controller or as a node on a PWC network, where several feeders form a distributed loss-in-weight batching system.


How does a loss-in-weight feeder controller differ from a batching controller?
A batching controller stops feeding when a target weight is reached. A loss-in-weight controller runs continuously: it measures how fast the hopper weight falls, compares that rate with the kg/h setpoint, and modulates the feeder speed to hold the rate. The TR700-LF is built for that continuous regulating job, including refill handling and rate calculation.
What feed rate accuracy can I expect?
Accuracy depends mainly on the feeder mechanics, refill disturbance and the load cell resolution you install. The module contributes a 16,000,000-count measurement chain, 0.005% full-scale nonlinearity and a predictive PID law with small overshoot, so the control side does not limit achievable accuracy. We recommend a short trial on your material to confirm the figure.
Can the TR700-LF run without a PWC system or PLC?
Yes. It can work as a stand-alone controller with setpoints entered locally, and it can later be added as a node on a PWC network to form a distributed loss-in-weight or belt scale batching system. All port functions can be customised for the machine builder.
Which feeders and load cells can it drive?
It suits screw feeders, vibratory feeders and small belt feeders. Up to eight 350 ohm load cells can be connected at 10 V excitation with 250 mA available, and pulse input is not required. Please confirm the feeder motor interface and drive signal with our engineers when ordering.
Does it support refill and hopper empty detection?
The module provides four isolated switch inputs and four relay outputs, which are used for refill valves, level switches and alarms, and it has a volume measurement mode for volumetric operation when weighing is disturbed. The exact refill logic is configured per project; send us your feeder sequence and we will confirm the setup.
Solutions & Support
We go the extra mile to thoroughly analyze each project and deliver tailored business solutions that meet your specific requirements.
Copyright © 2026 singoo Technical supp
Contact US
×




